Camburg 20″ x 3.0″ ID x 700# CRS 2.5 Coilover Spring

Code: CAM-010060
  • For 2.5″ coilovers only
  • 20″ x 3″ ID x 700/lbs. rate
  • Made in the USA

$150.00

In Stock

Description

With extensive spring testing on our Camburg Tundra 07-20 long-travel kit, we had Eibach custom build these coilover springs specifically for us for maximum spring travel and longevity. We wanted a spring with a smaller OD for more clearance at the tie rod and axle shaft and doing so required using a different spring material not to over-stress the spring while still offering maximum spring travel to eliminate coil binding and fatigue. This gave us a more linear rate and a higher block load for better bottoming resistance compared to a shorter 18″ length spring.

These also fill a void in the coilover spring market and can be used on many different trucks and race vehicles looking for the same benefits.

  • Ultra-lightweight for reduced un-sprung Mass
  • Maximum travel in combination with smallest block heights
  • Exceptional block resistance and durability
  • Precision tolerances
  • Precision plan-parallel and square end configurations under unloaded/loaded conditions to +/- 1 degree
  • Lowest side loads with load center ideally located relative to spring axis
  • Highest linearity and guaranteed rate consistency within 2% Of advertised rate
  • Each spring individually tested and rated
  • Sold individually

Spring Color: Flat Black
Spring Length: 20″
Spring OD: 4.57″
Spring ID: 3.00″
Spring Rate: 700 lbs/in
Spring Travel: 9.10″


CAProp65

  • Coil spring (sold individually)
MakeModelYear