Camburg 1.50 Uniball Replacement Kit

Code: CAM-010048

Made in the USA


In Stock


This kit is what’s required to rebuild the uniballs in your Camburg upper arms and some of our lower arms. The kit includes two FK 1.50 uniballs and two snap rings. These are made in the USA and are not some cheap imported parts.  They have a self-lubricating military grade PTFE liner internally for reduced stiction and noise. Having a 135,950 lbs. load rating, these are far stronger than OEM style ball-joints and cheaper or smaller uniball bearings. The bearing ID with the mis-alignment spacers removed is 1.50″ and the bearing OD is 2.75″.

Refer to our instructions for step-by-step directions.

Confirm sizing before ordering as some older version upper arms use a smaller 1.00″ uniball. Easiest way to tell is by the bolt. If the bolt is a hex head and above the uniball, than it’s a 1″ uniball as the 1.50″ has the bolt recessed below.


  • FK COMH-24T 1.50″ uniballs (2)
  • 1.50″ uniball snap rings (2)



You may also like…