Camburg 2.25 Rear Weld-in Snouts

Camburg 2.25 Rear Weld-in Snouts

Sku:

Quick Overview

These 2.25 hub snouts are CNC machined in-house from aircraft quality 4130 chromoly so you can weld them into your axle housing and later heat-treat if desired. These are also what we use in our complete rear ends that utilize our 2.25 hubs. These are complete and include the locking nut and hardware. We have updated these to our new locking nut design that uses a ring that bolts to the face of the nut and registers into the snout. We offer these in both right hand and left hand thread versions so order one of each when needing a set. Also select the correct tubing size of the axle housing you’re using.

Clear

These 2.25 hub snouts are CNC machined in-house from aircraft quality 4130 chromoly so you can weld them into your axle housing and later heat-treat if desired. These are also what we use in our complete rear ends that utilize our 2.25 hubs. These are complete and include the locking nut and hardware. We have updated these to our new locking nut design that uses a ring that bolts to the face of the nut and registers into the snout. We offer these in both right hand and left hand thread versions so order one of each when needing a set. Also select the correct tubing size of the axle housing you’re using.

  • Weld-in snout
  • Lock washer
  • Lock nut
Lift Wheel Travel Track Width Wheel Size Max Backspacing Tire Size Install Labor Alignment Specs
MakeModelYear
Top